ISO 8062-3:2023

International Standard   Current Edition · Approved on 15 February 2023

Geometrical product specifications (GPS) — Dimensional and geometrical tolerances for moulded parts — Part 3: General dimensional and geometrical tolerances and machining allowances for castings using ± tolerances for indicated dimensions

ISO 8062-3:2023 Files

English 34 Pages
Current Edition
74.47 OMR

ISO 8062-3:2023 Scope

This document specifies general dimensional and geometrical tolerances as well as machining allowance grades for castings using ± tolerances for indicated dimensions as delivered to the purchaser according to ISO/TS 8062-2. It is applicable for tolerancing of dimensions and geometry of castings in all cast metals and their alloys produced by various casting manufacturing processes.

This document does not apply to 3D CAD models used without indicated dimensions.

This document applies to both general dimensional and general geometrical tolerances (referred to in or near the title block of the drawing), unless otherwise specified and where specifically referred to on the drawing by one of the references in Clause 11.

The dimensional tolerances covered by this document are tolerances for linear dimensions.

The geometrical tolerances covered by this document are tolerances for:

     straightness;

     flatness;

     roundness;

     parallelism;

     perpendicularity;

     symmetry;

     coaxiality.

This document does not cover other position tolerances, angular dimensional tolerances or cylindricity tolerances.

This document can be used for the selection of tolerance values for individual indications.

Best Sellers

GSO 150-2:2013
 
Gulf Standard
Expiration dates for food products - Part 2 : Voluntary expiration dates
OS GSO 150-2:2013
GSO 150-2:2013 
Omani Standard
Expiration dates for food products - Part 2 : Voluntary expiration dates
OS GSO 2055-1:2015
GSO 2055-1:2015 
Omani Standard
HALAL FOOD - Part 1 : General Requirements
GSO 2055-1:2015
 
Gulf Technical Regulation
HALAL FOOD - Part 1 : General Requirements

Recently Published

ISO 20589:2025
 
International Standard
Glass in building — Determination of the emissivity
ISO 11265:2025
 
International Standard
Environmental solid matrices — Determination of the specific electrical conductivity
ISO 11465:2025
 
International Standard
Sludge and solid environmental matrices — Determination of dry residue or water content and calculation of the dry matter fraction on a mass basis
ISO 9350:2025
 
International Standard
Corrosion of metals and alloys — Testing method of corrosion resistance for hafnium at high temperature and pressure