ISO 286-2:1988
International Standard
Historical
·
Approved on
09 June 1988
ISO system of limits and fits — Part 2: Tables of standard tolerance grades and limit deviations for holes and shafts
ISO 286-2:1988 Files
English
43 Pages
Historical
30.33 OMR
ISO 286-2:1988 Scope
This part gives of the limit deviations for commonly used tolerance classes calculated from the information given in ISO 286-1. It covers values for the upper and the lower deviations which are illustrated by a figure. It tabulates numerical values for basic sizes from 3 mm up to and including 3150 mm. An annex gives a graphical review of tolerance zones.
Best Sellers
GSO 150-2:2013
Gulf Standard
Expiration dates for food products - Part 2 :
Voluntary expiration dates
OS GSO 150-2:2013
GSO 150-2:2013
Omani Standard
Expiration dates for food products - Part 2 :
Voluntary expiration dates
OS GSO 2055-1:2015
GSO 2055-1:2015
Omani Standard
HALAL FOOD - Part 1 : General Requirements
GSO 2055-1:2015
Gulf Technical Regulation
HALAL FOOD - Part 1 : General Requirements
Recently Published
OS 1658:2025:2025
Omani Standard
Disposable Garbage Bags
ISO 7718-2:2025
International Standard
Aircraft — Passenger doors interface requirements for connection of passenger boarding bridge or passenger transfer vehicle — Part 2: Upper deck doors
ISO/IEC/IEEE 32430:2025
International Standard
Software engineering — Software non-functional size measurement
ISO 10218-1:2025
International Standard
Robotics — Safety requirements — Part 1: Industrial robots