GSO EN 13445-5:2021+A1:2024

EN 13445-5:2021+A1:2024
Gulf Standard   Current Edition · Approved on 14 October 2024

Unfired pressure vessels - Part 5: Inspection and testing

GSO EN 13445-5:2021+A1:2024 Files

GSO EN 13445-5:2021+A1:2024 Scope

This Part of this document specifies the inspection and testing of individual and serially produced pressure vessels made of steels in accordance with EN 13445-2:2021. Special provisions for cyclic operation are given in Annex G of this Part. Special provisions for vessels or vessel parts working in the creep range are given in Annex F and Annex I of this Part. NOTE The responsibilities of parties involved in the conformity assessment procedures are given in Directive 2014/68/EU. Guidance on this can be found in CR 13445-7.

Best Sellers From Mechanical Sector

OS GSO 42:2015
GSO 42:2015 
Omani Standard
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
OS GSO 159:1993
GSO 159:1993 
Omani Standard
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS

Recently Published from Mechanical Sector

GSO EN 13445-6:2024
EN 13445-6:2021 
Gulf Standard
Unfired pressure vessels - Part 6: Requirements for the design and fabrication of pressure vessels and pressure parts constructed from spheroidal graphite cast iron
GSO ISO 11154:2024
ISO 11154:2023 
Gulf Standard
Road vehicles — Roof load carriers
GSO ISO 10468:2024
ISO 10468:2023 
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes — Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023 
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors