ISO 21364-1:2025

International Standard   Current Edition · Approved on 03 June 2025

Domestic gas cooking appliances — Safety — Part 1: General requirements

ISO 21364-1:2025 Files

English 83 Pages
Current Edition
106.01 OMR

ISO 21364-1:2025 Scope

This document specifies the safety requirements for domestic gas cooking appliances. This covers appliances that are freestanding, built-in or table-top and are intended to be used indoors. This document applies to the gas sections of the appliances and their component parts (e.g. combined gas-electric cooking appliances). This document does not apply to:

a)       electrical heated elements as part of the appliance;

b)       outdoor appliances;

c)        appliances supplied at pressures greater than the maximum pressure of the test gases;

d)       cook stoves covered by the standards developed by ISO/TC 285.

In general, it does not take into account children playing with the appliance.

NOTE 1        For requirements regarding electrical safety, refer to the IEC 60335 series.

NOTE 2        Attention is drawn to the fact that:

      for appliances intended to be used in vehicles or on board of ships or aircrafts, additional requirements can apply;

      in many countries, additional requirements are specified by the national health authorities, the national water supply authorities and similar authorities.

This document does not cover requirements relating to gas cylinders, their pressure regulators and their connections.

This document does not cover requirements for gas installation.

Best Sellers

GSO 150-2:2013
 
Gulf Standard
Expiration dates for food products - Part 2 : Voluntary expiration dates
OS GSO 150-2:2013
GSO 150-2:2013 
Omani Standard
Expiration dates for food products - Part 2 : Voluntary expiration dates
OS GSO 2055-1:2015
GSO 2055-1:2015 
Omani Standard
HALAL FOOD - Part 1 : General Requirements
GSO 2055-1:2015
 
Gulf Technical Regulation
HALAL FOOD - Part 1 : General Requirements

Recently Published

ISO 13909-8:2025
 
International Standard
Coal and coke — Mechanical sampling — Part 8: Methods of testing for bias
ISO/IEC 16466:2025
 
International Standard
Information technology — 3D printing and scanning — Assessment methods of 3D scanned data use in 3D printing
ISO 18960:2025
 
International Standard
Security controls and implementation for third party payment service providers — Guidance and requirements
ISO 5684:2025
 
International Standard
Adhesives — Floor covering adhesives and products for flooring installation — Assessment and classification of low volatile organic compound (VOC) products