GSO ISO 16422-1:2025

ISO 16422-1:2024
Gulf Standard   Current Edition · Approved on 14 October 2025

Pipes and joints made of oriented unplasticized poly(vinyl chloride) (PVC-O) for the conveyance of water under pressure — Part 1: General

GSO ISO 16422-1:2025 Files

English 8 Pages
Current Edition Reference Language
OMR 30.71

GSO ISO 16422-1:2025 Scope

This document specifies the general characteristics of solid-wall pipes made of oriented unplasticized poly(vinyl chloride) (PVC-O) for piping systems intended to be used underground or above-ground (where protected from direct sunlight), for water supply, buried drainage, sewerage, treated waste water and irrigation under pressure.

In conjunction with ISO 16422-2, ISO/TS 16422-3, ISO 16422-5 and ISO 1452-4, this document is applicable to PVC-O pipes and PVC-O fittings, as well as to valves, their joints and to joints with components of other plastics and non-plastics materials intended to be used for the following:

a)       water mains and services lines;

b)       conveyance of water for both outside and inside buildings;

c)        drainage, sewerage and treated wastewater under pressure;

d)       irrigation under pressure.

This document is applicable to piping systems intended for the supply of water under pressure up to and including 25 °C (cold water), intended for human consumption and for general purposes as well as for wastewater under pressure.

This document is also applicable to components for the conveyance of water and wastewater up to and including 45 °C. For temperatures between 25 °C and 45 °C, see ISO 16422-2:2023, Figure C.1.

The piping system according to this document is intended for the conveyance of cold water up to pressures of 25 bar[1] and especially in those applications where special performance requirements are needed, such as impact loads and pressure fluctuations, up to pressure of 25 bar.

[1]  1 bar = 0,1 MPa = 105 Pa; 1 MPa = 1 N/mm2

Best Sellers From Mechanical Sector

OS GSO 42:2015
GSO 42:2015 
Omani Standard
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
OS GSO 159:1993
GSO 159:1993 
Omani Standard
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS

Recently Published from Mechanical Sector

GSO ISO 34505:2026
ISO 34505:2025 
Gulf Standard
Road vehicles — Test scenarios for automated driving systems — Scenario evaluation and test case generation
GSO ISO 4254-9:2026
ISO 4254-9:2018 
Gulf Standard
Agricultural machinery — Safety — Part 9: Seed drills
GSO ISO 6531:2026
ISO 6531:2024 
Gulf Standard
Machinery for forestry — Portable chain-saws — Vocabulary
GSO ISO 7141:2026
ISO 7141:2022 
Gulf Standard
Road vehicles — Light alloy wheels — Lateral impact test