GSO EN 10346:2024
EN 10346:2015
Gulf Standard
Current Edition
·
Approved on
14 October 2024
Continuously hot-dip coated steel flat products for cold forming - Technical delivery conditions
GSO EN 10346:2024 Files
No files are available for this standard right now!
GSO EN 10346:2024 Scope
This European Standard specifies requirements for continuously hot-dip coated products made of low carbon steels for cold forming, of steels for construction, of steels with high proof strength for cold forming and coated with zinc (Z), zinc-iron alloy (ZF), zinc-aluminium alloy (ZA), aluminium-zinc alloy (AZ), aluminium-silicon alloy (AS) or zinc-magnesium alloy (ZM) and for continuously hot-dip coated products made of multiphase steels for cold forming coated with zinc (Z), zinc-iron alloy (ZF), zinc-aluminium alloy (ZA) or zinc-magnesium alloy (ZM) in thicknesses of 0,20 mm ≤ t < 3,0 mm.
By agreement at the time of enquiry and order, this European Standard is applicable to continuously hot-dip coated flat products of an expanded validity range defined for thicknesses t < 0,20mm or in thicknesses 3,0mm < t < 6,5mm with agreed mechanical properties and test specimens, adhesion of coating and surface condition requirements.
The thickness is the final thickness of the delivered product after coating.
This document applies to strip of all widths and to sheets cut from it (≥ 600 mm width) and cut lengths
(< 600 mm width).
NOTE 1 Products coated with (pure) aluminium can also be available, but are not covered by this European standard.
NOTE 2 The products covered by this European Standard are used where cold formability, high strength, a defined minimum yield strength and corrosion resistance are the most important factors. Corrosion resistance of the product is proportional to the coating thickness, hence to its mass (see also 7.3.2). The products covered by this European Standard can be used as substrates for organic coated flat products specified in EN 10169 for building and general engineering applications.
NOTE 3 By agreement at the time of enquiry and order, this European standard is applicable to other continuously hot-dip coated hot rolled steel flat products (e.g. in accordance with EN 10149-2).
Best Sellers From Construction and Building Sector
GSO 1431:2002
Gulf Technical Regulation
Sanitary appliances - pressurized flushing devices
OS GSO 1431:2002
GSO 1431:2002
Omani Standard
Sanitary appliances - pressurized flushing devices
GSO 1427:2008
Gulf Standard
Ceramic Sanitary Appliances - Western Water Closets
OS GSO 1427:2008
GSO 1427:2008
Omani Standard
Ceramic Sanitary Appliances - Western Water Closets
Recently Published from Construction and Building Sector
GSO ASTM C1224:2024
ASTM C1224:22
Gulf Standard
Standard Specification for Reflective Insulation for Building Applications
GSO ASTM E631:2024
ASTM E631:15(2024)
Gulf Standard
Standard Terminology of Building Constructions
GSO ISO 20760-1:2024
ISO 20760-1:2018
Gulf Standard
Water reuse in urban areas
— Guidelines for centralized water reuse system
— Part 1: Design principle of a centralized water reuse system
GSO ISO 52000-3:2024
ISO 52000-3:2023
Gulf Standard
Energy performance of buildings
— Overarching EPB assessment
— Part 3: General principles for determination and reporting of primary energy factors (PEF) and CO2 emission coefficients