GSO ISO 23551-9:2024

ISO 23551-9:2022
Gulf Standard   Current Edition · Approved on 14 October 2024

Safety and control devices for gas burners and gas-burning appliances — Particular requirements — Part 9: Mechanical gas thermostats

GSO ISO 23551-9:2024 Files

GSO ISO 23551-9:2024 Scope

This document specifies safety, construction, performance and testing requirements for mechanical gas thermostat intended for use with gas burners and gas burning appliances hereafter referred to as “thermostats”.

This document applies to mechanical gas thermostats of nominal connection sizes up to and including DN 50 with declared maximum inlet pressures up to and including 50 kPa, for use with natural gas, manufactured gas or liquefied petroleum gas (LPG). It is not applicable to corrosive and waste gases.

This document applies to mechanical thermostats:

—    controlling the gas flow directly or indirectly through an integral gas valve, and which do not require external electrical energy for their operation;

—    used on gas appliances where the thermostat is not directly exposed to the outdoor environment; and

—    which are intended for operating control functions.

This document covers type testing only.

Best Sellers From Mechanical Sector

OS GSO 42:2015
GSO 42:2015 
Omani Standard
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
OS GSO 159:1993
GSO 159:1993 
Omani Standard
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS

Recently Published from Mechanical Sector

GSO ISO 11154:2024
ISO 11154:2023 
Gulf Standard
Road vehicles — Roof load carriers
GSO ISO 10468:2024
ISO 10468:2023 
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes — Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023 
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors
GSO ISO 11114-5:2024
ISO 11114-5:2022 
Gulf Standard
Gas cylinders — Compatibility of cylinder and valve materials with gas contents — Part 5: Test methods for evaluating plastic liners