GSO ASTM D1142:2024

ASTM D1142:95(2021)
Gulf Standard   Current Edition · Approved on 14 October 2024

Standard Test Method for Water Vapor Content of Gaseous Fuels by Measurement of Dew-Point Temperature

GSO ASTM D1142:2024 Files

GSO ASTM D1142:2024 Scope

1.1 This test method covers the determination of the water vapor content of gaseous fuels by measurement of the dew-point temperature and the calculation therefrom of the water vapor content.

Note 1: Some gaseous fuels contain vapors of hydrocarbons or other components that easily condense into liquid and sometimes interfere with or mask the water dew point. When this occurs, it is sometimes very helpful to supplement the apparatus in Fig. 1 with an optical attachment that uniformly illuminates the dew–point mirror and also magnifies the condensate on the mirror. With this attachment it is possible, in some cases, to observe separate condensation points of water vapor, hydrocarbons, and glycolamines as well as ice points. However, if the dew point of the condensable hydrocarbons is higher than the water vapor dew point, when such hydrocarbons are present in large amounts, they may flood the mirror and obscure or wash off the water dew point. Best results in distinguishing multiple component dew points are obtained when they are not too closely spaced.

FIG. 1 Bureau of Mines Dew-Point Apparatus

 Bureau of Mines Dew-Point Apparatus Bureau of Mines Dew-Point Apparatus

Note 2: Condensation of water vapor on the dew-point mirror may appear as liquid water at temperatures as low as 0 to −10°F (−18 to −23°C). At lower temperatures an ice point rather than a water dew point likely will be observed. The minimum dew point of any vapor that can be observed is limited by the mechanical parts of the equipment. Mirror temperatures as low as −150°F (−100°C) have been measured, using liquid nitrogen as the coolant with a thermocouple attached to the mirror, instead of a thermometer well.

1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Best Sellers From Oil and Gas Sector

GSO 1180:2021
 
Gulf Standard
Automatic transmission fluid (ATF)
OS GSO 672:2010
GSO 672:2010 
Omani Standard
Liquefied petroleum gases (LPG) for household use( mixture of commerical propane and butane).
GSO 672:2010
 
Gulf Standard
Liquefied petroleum gases (LPG) for household use( mixture of commerical propane and butane).
GSO 1161:2021
 
Gulf Standard
HLP HYDRAULIC OILS

Recently Published from Oil and Gas Sector

GSO ASTM D4468:2024
ASTM D4468:23 
Gulf Standard
Standard Test Method for Total Sulfur in Gaseous Fuels by Hydrogenolysis and Rateometric Colorimetry
GSO ISO 24202:2024
ISO 24202:2023 
Gulf Standard
Oil and gas industries including lower carbon energy — Bulk material for offshore projects — Monorail beam and padeye
GSO ISO/TS 16922:2024
ISO/TS 16922:2022 
Gulf Standard
Natural gas — Odorization
GSO ASTM D7940:2024
ASTM D7940:21 
Gulf Standard
Standard Practice for Analysis of Liquefied Natural Gas (LNG) by Fiber-Coupled Raman Spectroscopy