GSO ISO/ASTM 51631:2024

Gulf Standard   Current Edition
· Approved on 25 April 2024 ·

Practice for use of calorimetric dosimetry systems for dose measurements and dosimetry system calibration in electron beams

Radiation measurements
Including dosimetry

GSO ISO/ASTM 51631:2024 Files

English 0 Pages
Current Edition Reference Language

GSO ISO/ASTM 51631:2024 Scope

This practice covers the preparation and use of semiadiabatic calorimetric dosimetry systems for measurement of

absorbed dose and for calibration of routine dosimetry systems when irradiated with electrons for radiation processing applications.

The calorimeters are either transported by a conveyor past a scanned electron beam or are stationary in a broadened

beam.

This document is one of a set of standards that provides recommendations for properly implementing dosimetry in radiation processing, and describes a means of achieving compliance with the requirements of ISO/ASTM Practice

52628 for a calorimetric dosimetry system. It is intended to be read in conjunction with ISO/ASTM Practice 52628.

The calorimeters described in this practice are classified as Type II dosimeters on the basis of the complex effect of influence quantities. See ISO/ASTM Practice 52628.

This practice applies to electron beams in the energy range from 1.5 to 12 MeV.

The absorbed dose range depends on the calorimetric absorbing material and the irradiation and measurement conditions. Minimum dose is approximately 100 Gy and maximum dose is approximately 50 kGy.

The average absorbed-dose rate range shall generally be greater than 10 Gy·s-1.

The temperature range for use of these calorimetric dosimetry systems depends on the thermal resistance of the calorimetric materials, on the calibration range of the temperature sensor, and on the sensitivity of the measurement device.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Best Sellers From Metrology Sector

GSO OIML R87:2021
OIML R87:2016 
Gulf Standard
Quantity of product in prepackages
GSO OIML R79:2021
OIML R79:2015 
Gulf Standard
Labeling requirements for prepackages
OS GSO OIML R76-1:2009
GSO OIML R 76-1:2009 
Omani Standard
Non-automatic weighing instruments – Part 1: Metrological and technical requirements - Tests
GSO OIML R 76-1:2009
OIML R 76-1:2006 
Gulf Standard
Non-automatic weighing instruments – Part 1: Metrological and technical requirements - Tests

Recently Published from Metrology Sector

GSO IEC 62586-1:2024
IEC 62586-1:2017 
Gulf Standard
Power quality measurement in power supply systems - Part 1: Power quality instruments (PQI)
GSO ISO 748:2024
ISO 748:2021 
Gulf Standard
Hydrometry — Measurement of liquid flow in open channels — Velocity area methods using point velocity measurements
GSO ISO 14405-2:2024
ISO 14405-2:2018 
Gulf Standard
Geometrical product specifications (GPS) — Dimensional tolerancing — Part 2: Dimensions other than linear or angular sizes
GSO ASTM E2847:2024
ASTM E2847:21 
Gulf Standard
Standard Test Method for Calibration and Accuracy Verification of Wideband Infrared Thermometers