GSO EN 17344:2024
EN 17344:2020
Gulf Standard
Current Edition
·
Approved on
31 January 2024
Agricultural machinery - Self-propelled agricultural and forestry vehicles - Requirements for braking
GSO EN 17344:2024 Files
English
38 Pages
Current Edition
Reference Language
GSO EN 17344:2024 Scope
This document applies to wheeled and/or track-laying self-propelled agricultural and forestry vehicles when used on public roads. It specifies the definitions, construction and performance requirements and the means for verification of braking systems on vehicles with a maximum design speed not exceeding 60 km/h.
Following items are excluded from the scope of this document:
- coupling force control;
- endurance braking systems;
- Anti-Lock Braking Systems and EBS;
- vacuum braking systems;
- safety related parts of complex electronic control systems;
- trailer braking control systems.
NOTE For assisted trailer braking the EU Regulation 2015/68 can be used but before including these requirements into this document, an additional review of 2015/68 is needed.
Best Sellers From Mechanical Sector
OS GSO 42:2015
GSO 42:2015
Omani Standard
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
OS GSO 159:1993
GSO 159:1993
Omani Standard
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
Recently Published from Mechanical Sector
GSO ISO 10468:2024
ISO 10468:2023
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes
— Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors
GSO ISO 11114-5:2024
ISO 11114-5:2022
Gulf Standard
Gas cylinders
— Compatibility of cylinder and valve materials with gas contents
— Part 5: Test methods for evaluating plastic liners
GSO ISO 4211-5:2024
ISO 4211-5:2021
Gulf Standard
Furniture
— Tests for surface finishes
— Part 5: Assessment of resistance to abrasion