GSO ISO 13185-2:2021

ISO 13185-2:2015
Gulf Standard   Current Edition · Approved on 01 July 2021

Intelligent transport systems — Vehicle interface for provisioning and support of ITS services — Part 2: Unified gateway protocol (UGP) requirements and specification for vehicle ITS station gateway (V-ITS-SG) interface

GSO ISO 13185-2:2021 Files

GSO ISO 13185-2:2021 Scope

ISO 13185-2:2015 specifies the requirements of an ASN.1-based protocol between a vehicle-ITS-Station Gateway (V-ITS-SG) and a nomadic and/or mobile device (ND) to easily exchange vehicle information data.

The ASN.1-based protocol has been specified to support a wired or wireless connection between the ND and V-ITS-SG.

The Unified Gateway Protocol (UGP) is used between the V-ITS-SG and the ND. UGP supports several features in order to provide

· authorization (data privacy),

· secured access,

· V-ITS-SG and in-vehicle ECUs identification,

· real-time vehicle data parameters with identifier and type information in ASN.1 format, and

· enhanced vehicle data parameters with identifier and type information in ASN.1 format.

Best Sellers From Mechanical Sector

OS GSO 42:2015
GSO 42:2015 
Omani Standard
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
OS GSO 159:1993
GSO 159:1993 
Omani Standard
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS

Recently Published from Mechanical Sector

GSO EN 13445-6:2024
EN 13445-6:2021 
Gulf Standard
Unfired pressure vessels - Part 6: Requirements for the design and fabrication of pressure vessels and pressure parts constructed from spheroidal graphite cast iron
GSO ISO 11154:2024
ISO 11154:2023 
Gulf Standard
Road vehicles — Roof load carriers
GSO ISO 10468:2024
ISO 10468:2023 
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes — Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023 
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors