GSO ISO 18375:2021

ISO 18375:2016
Gulf Standard   Current Edition · Approved on 01 July 2021

Heavy commercial vehicles and buses — Test method for yaw stability — Sine with dwell test

GSO ISO 18375:2021 Files

GSO ISO 18375:2021 Scope

ISO 18375:2016 describes an open-loop test method for determining the yaw stability of a vehicle on a low friction road surface. It applies to heavy vehicles, that is commercial vehicles, commercial vehicle combinations, buses and articulated buses as defined in ISO 3833 (trucks and trailers with maximum weight above 3,5 tonnes and buses and articulated buses with maximum weight above 5 tonnes, according to ECE and EC vehicle classification, categories M3, N2, N3, O3 and O4).

The method is intended for vehicles equipped with electronic yaw-stability control systems.

As the results of this test depend largely on local and temporary changes in road surface friction, this International Standard gives recommendations about keeping the friction level as uniform as possible for good reproducibility of the test results.

Best Sellers From Mechanical Sector

OS GSO 42:2015
GSO 42:2015 
Omani Standard
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
OS GSO 159:1993
GSO 159:1993 
Omani Standard
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS

Recently Published from Mechanical Sector

GSO EN 13445-6:2024
EN 13445-6:2021 
Gulf Standard
Unfired pressure vessels - Part 6: Requirements for the design and fabrication of pressure vessels and pressure parts constructed from spheroidal graphite cast iron
GSO ISO 11154:2024
ISO 11154:2023 
Gulf Standard
Road vehicles — Roof load carriers
GSO ISO 10468:2024
ISO 10468:2023 
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes — Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023 
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors