GSO ISO 5610-15:2016
ISO 5610-15:2014
Gulf Standard
Current Edition
·
Approved on
22 December 2016
Tool holders with rectangular shank for indexable inserts -- Part 15: Style V
GSO ISO 5610-15:2016 Files
English
5 Pages
Current Edition
Reference Language
OMR
20.35
GSO ISO 5610-15:2016 Scope
This part of ISO 5610 specifies tool holders with rectangular shank, style V, i.e. with straight shank and cutting edge angle κr = 72,5° for side cutting.
These tool holders are primarily intended for indexable inserts made of hard metal or other cutting materials to be mounted by clamping and to be used for turning operations.
NOTE The symbols for the dimensions shown in the tables of this part of ISO 5610 and the corresponding preferred symbols of properties defined in ISO/TS 13399-2 and ISO/TS 13399-3 are given in ISO 5610-1:2014, Table A.1.
Best Sellers From Mechanical Sector
OS GSO 42:2015
GSO 42:2015
Omani Standard
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
OS GSO 159:1993
GSO 159:1993
Omani Standard
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
Recently Published from Mechanical Sector
GSO EN 131-3:2018+A1:2026
EN 131-3:2018+A1:2025
Gulf Standard
Ladders - Part 3: Marking and user instructions
OS GSO EN 17860-1:2026
EN 17860-1:2024
Omani Standard
Carrier cycles - Part 1: Terms and definitions
OS GSO ISO 17987-3:2026
ISO 17987-3:2025
Omani Standard
Road vehicles — Local Interconnect Network (LIN) — Part 3: Protocol specification
OS GSO EN 17860-2:2024+A1:2026
EN 17860-2:2024+A1:2026
Omani Standard
Carrier Cycles - Part 2: Lightweight single track carrier cycles - Mechanical aspects