GSO ISO 13693-2:2016

ISO 13693-2:2015
Gulf Standard   Current Edition · Approved on 22 December 2016

Irrigation equipment -- Safety devices for chemigation -- Part 2: Chemigation valve assemblies from DN 75 (3") to DN 350 (14")

GSO ISO 13693-2:2016 Files

English 8 Pages
Current Edition Reference Language
27.07 OMR

GSO ISO 13693-2:2016 Scope

This part of ISO 13693 specifies the construction and performance requirement and test methods for metal-bodied chemigation valves with water at temperatures not exceeding 50 °C, which might contain fertilizers and chemicals of the types and concentration used in agriculture. The valve is designed to prohibit backflow caused by either back pressure or back siphonage. It is not designed for use in potable water systems. It is not to be confused with other forms of backflow prevention devices including pressure vacuum breakers, double check valves, reduced pressure zone valves, or goose neck loops. This part of ISO 13693 specifies the minimum design, construction, and performance testing requirements for the chemigation valve assembly. The assembly consists of the following components: — a valve body into which a spring-loaded check valve is mounted with a resilient disk cover on the sealing surface; — a combination air release/vacuum relief valve located upstream of the check valve; — a low pressure drain valve located upstream of the check valve; — an inspection port located so as to permit visual and manual inspection of the valve working components.

Best Sellers From Mechanical Sector

OS GSO 42:2015
GSO 42:2015 
Omani Standard
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
OS GSO 159:1993
GSO 159:1993 
Omani Standard
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS

Recently Published from Mechanical Sector

GSO ISO 10468:2024
ISO 10468:2023 
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes — Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023 
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors
GSO ISO 11114-5:2024
ISO 11114-5:2022 
Gulf Standard
Gas cylinders — Compatibility of cylinder and valve materials with gas contents — Part 5: Test methods for evaluating plastic liners
GSO ISO 4211-5:2024
ISO 4211-5:2021 
Gulf Standard
Furniture — Tests for surface finishes — Part 5: Assessment of resistance to abrasion