GSO ISO 3937-3:2015
ISO 3937-3:2008
Gulf Standard
Current Edition
·
Approved on
03 September 2015
Cutter arbors with tenon drive -- Part 3: Dimensions of hollow taper interface with flange contact surface
GSO ISO 3937-3:2015 Files
English
5 Pages
Current Edition
Reference Language
19.96 OMR
GSO ISO 3937-3:2015 Scope
This part of ISO 3937 specifies the dimensions of cutter arbors with tenon drive and with hollow taper interface with
flange contact surface (HSK). It also specifies the dimensions of cutter arbors with tenon drive and enlarged contact surface of the cutters.
The interchangeability dimensions of the milling cutter bearing on the cutter arbor are in conformity with ISO 2780. The dimensions of the retaining screw used are specified in ISO 2780.
The hollow taper interface with flange contact surface is in conformance with ISO 12164-1.
Best Sellers From Mechanical Sector
OS GSO 42:2015
GSO 42:2015
Omani Standard
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
OS GSO 159:1993
GSO 159:1993
Omani Standard
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
Recently Published from Mechanical Sector
GSO EN 13445-6:2024
EN 13445-6:2021
Gulf Standard
Unfired pressure vessels - Part 6: Requirements for the design and fabrication of pressure vessels and pressure parts constructed from spheroidal graphite cast iron
GSO ISO 11154:2024
ISO 11154:2023
Gulf Standard
Road vehicles — Roof load carriers
GSO ISO 10468:2024
ISO 10468:2023
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes
— Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors