GSO ISO 9999:2014
ISO 9999:2011
Gulf Standard
Current Edition
·
Approved on
25 December 2014
Assistive products for persons with disability -- Classification and terminology
GSO ISO 9999:2014 Files
English
100 Pages
Current Edition
Reference Language
27.27 OMR
GSO ISO 9999:2014 Scope
This International Standard establishes a classification of assistive products, especially produced or generally available, for persons with disability.
Assistive products used by a person with disability, but which require the assistance of another person for their operation, are included in the classification.
The following items are specifically excluded from this International Standard:
— items used for the installation of assistive products;
— solutions obtained by combinations of assistive products that are individually classified in this International Standard;
— medicines;
— assistive products and instruments used exclusively by healthcare professionals;
— non-technical solutions, such as personal assistance, guide dogs or lip-reading;
— implanted devices;
— financial support.
Best Sellers From Mechanical Sector
OS GSO 42:2015
GSO 42:2015
Omani Standard
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
OS GSO 159:1993
GSO 159:1993
Omani Standard
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
Recently Published from Mechanical Sector
GSO ISO 10468:2024
ISO 10468:2023
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes
— Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors
GSO ISO 11114-5:2024
ISO 11114-5:2022
Gulf Standard
Gas cylinders
— Compatibility of cylinder and valve materials with gas contents
— Part 5: Test methods for evaluating plastic liners
GSO ISO 4211-5:2024
ISO 4211-5:2021
Gulf Standard
Furniture
— Tests for surface finishes
— Part 5: Assessment of resistance to abrasion