GSO ISO 7129:2013
ISO 7129:1997
Gulf Standard
Current Edition
·
Approved on
31 December 2013
Earth-moving machinery -- Cutting edges used on tractor-dozers, graders and scrapers -- Principal shapes and basic dimensions
GSO ISO 7129:2013 Files
English
12 Pages
Current Edition
Reference Language
OMR
31.08
GSO ISO 7129:2013 Scope
This International Standard specifies
— the principal shapes and dimensions of the cross-section,
— the hole location for the mounting bolts,
— the shapes and dimensions of holes for the mounting bolts,
for cutting used on tractor-dozers, graders and scrapers, as defined in ISO 6165, taking interchangeability into consideration.
NOTE Some values in inches in this International Standard are not equivalent to the corresponding values in millimetres because widely used values have been adopted.
Best Sellers From Mechanical Sector
OS GSO 42:2015
GSO 42:2015
Omani Standard
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
OS GSO 159:1993
GSO 159:1993
Omani Standard
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
Recently Published from Mechanical Sector
GSO ISO 7240-27:2026
ISO 7240-27:2025
Gulf Standard
Fire detection and alarm systems — Part 27: Point type fire detectors using a smoke sensor in combination with a carbon monoxide sensor and, optionally, one or more heat sensors
GSO EN 131-3:2018+A1:2026
EN 131-3:2018+A1:2025
Gulf Standard
Ladders - Part 3: Marking and user instructions
GSO ISO 16123:2026
ISO 16123:2025
Gulf Standard
Ships and marine technology — Marine cranes — Slewing bearings
GSO ASTM D8002:2026
ASTM D8002:24
Gulf Standard
Standard Test Method for Modified Fouling Index (MFI-0.45) of Water
