GSO EN 1570-1:2013

EN 1570-1:2011
Gulf Standard   Current Edition · Approved on 09 September 2013

Safety requirements for lifting tables- Part 1: Lifting tables serving up to two fixed landings

GSO EN 1570-1:2013 Files

English 68 Pages
Current Edition Reference Language

GSO EN 1570-1:2013 Scope

1.1 This European Standard specifies the safety requirements for industrial lifting tables for raising and/or lowering goods and the operator(s):  where the lifting table does not pass a fixed landing;  serving not more than 2 fixed landings. 1.2 This European Standard deals with all significant hazards pertinent to lifting tables when they are used as intended by the operating instructions and under the conditions foreseen (including foreseeable misuse) with the operating instructions (see Clause 4). This European Standard specifies the appropriate technical measures to eliminate or reduce the risks arising from the significant hazards. 1.3 Both power operated and manually operated lifting tables are included whether stationary or mobile.

Best Sellers From Mechanical Sector

OS GSO 42:2015
GSO 42:2015 
Omani Standard
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
OS GSO 159:1993
GSO 159:1993 
Omani Standard
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS

Recently Published from Mechanical Sector

GSO ISO 10468:2024
ISO 10468:2023 
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes — Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023 
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors
GSO ISO 11114-5:2024
ISO 11114-5:2022 
Gulf Standard
Gas cylinders — Compatibility of cylinder and valve materials with gas contents — Part 5: Test methods for evaluating plastic liners
GSO ISO 4211-5:2024
ISO 4211-5:2021 
Gulf Standard
Furniture — Tests for surface finishes — Part 5: Assessment of resistance to abrasion