GSO ISO 13715:2013
ISO 13715:2000
Gulf Standard
Current Edition
·
Approved on
09 September 2013
Technical drawings -- Edges of undefined shape -- Vocabulary and indications
GSO ISO 13715:2013 Files
English
13 Pages
Current Edition
Reference Language
30.06 OMR
GSO ISO 13715:2013 Scope
This International Standard defines the terms defining the states of edges and specifies rules for representing states of edges of undefined shape in technical drawings.
The proportions and dimensions of the graphical symbols to be used are also specified.
In cases where the geometrically defined shape of an edge (1 × 45°, for example) is required, the general dimensioning principles given in ISO 129-1 apply.
Best Sellers From Mechanical Sector
OS GSO 42:2015
GSO 42:2015
Omani Standard
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
OS GSO 159:1993
GSO 159:1993
Omani Standard
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
Recently Published from Mechanical Sector
GSO EN 13445-6:2024
EN 13445-6:2021
Gulf Standard
Unfired pressure vessels - Part 6: Requirements for the design and fabrication of pressure vessels and pressure parts constructed from spheroidal graphite cast iron
GSO ISO 11154:2024
ISO 11154:2023
Gulf Standard
Road vehicles — Roof load carriers
GSO ISO 10468:2024
ISO 10468:2023
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes
— Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors