GSO ISO 3739-1:2013
ISO 3739-1:2007
Gulf Standard
Historical
·
Approved on
09 September 2013
Industrial tyres and rims -- Part 1: Pneumatic tyres (metric series) on 5 degrees tapered or flat base rims -- Designation, dimensions and marking
GSO ISO 3739-1:2013 Files
English
12 Pages
Historical
Reference Language
30.51 OMR
GSO ISO 3739-1:2013 Scope
This part of ISO 3739 specifies the main requirements of the metric series of pneumatic tyres primarily intended for industrial vehicles, including designations, dimensions and markings. The tyres are based on the following parameters:
— speeds not exceeding 50 km/h;
— use on 5° tapered or flat base rims.
The conversion of code-designated industrial tyres into metric-designated tyres is outside the scope of this part of ISO 3739.
Best Sellers From Mechanical Sector
OS GSO 42:2015
GSO 42:2015
Omani Standard
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
OS GSO 159:1993
GSO 159:1993
Omani Standard
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
Recently Published from Mechanical Sector
GSO EN 13445-6:2024
EN 13445-6:2021
Gulf Standard
Unfired pressure vessels - Part 6: Requirements for the design and fabrication of pressure vessels and pressure parts constructed from spheroidal graphite cast iron
GSO ISO 11154:2024
ISO 11154:2023
Gulf Standard
Road vehicles — Roof load carriers
GSO ISO 10468:2024
ISO 10468:2023
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes
— Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors