GSO EN 415-2:2009
Gulf Standard
Current Edition
·
Approved on
17 October 2009
·
Packaging machines safety - Part 2 : Pre-formed rigid container packaging machines
GSO EN 415-2:2009 Files
English
72 Pages
Current Edition
Reference Language
GSO EN 415-2:2009 Scope
This standard specifies the safety requirements for the design and manufacture of
pre-formed rigid container packaging machinery and the information that should
be made available to the user of these machines.
All the significant hazards (see clause 4) arising from the machines included in
this part of the standard are covered except for hazards associated with ancillary
equipment for evacuating gases, cooling/refrigeration equipment associated with
packaging machines, steam services supplying packaging machines, substances
being filled (see annex C for guidance), hygiene principles (see annex D for
guidance) and substances for cleaning/sterilising (see annex E for guidance).
The following machines are included:
- Filling machines (other than cask, keg and barrel filling machines)
- Capping, closing and sealing/seaming machines
- Container cleaning machines (other than cask, keg and barrel cleaning
machines)
- In-line and rotary rinsing and air cleaning machines
- Labelling, decorating, coding and marking machines
- Decapping/unscrewing machines
- Inspection and ejection machines
- Machines that apply wiring to secure stoppers in bottles
- Machines which rinse, inspect, fill, seal and label containers
- Keg and cask turning, pushing, cleaning and filling machines (but not multi-lane
plants)
- Packing, unpacking and unscrambling machines
- Unpressurised pasteurisers and back-cooling machines
- Vertical and horizontal sterilising machines
For information, schematic drawings showing typical combinations of rigid
container packaging machines for beverages are included (see Figures 1, 2
and 3).
The following machines are not included:
- Aerosol Filling and Sealing
- Multi-lane Kegging plants
- Conveyor systems which link packaging machines (they are dealt with by
prEN 617, prEN 618, prEN 619, prEN 620 and prEN 741)
Before this standard is used a hazard identification and risk assessment shall be
carried out to check that the hazards for the machine to be designed are the same
as those identified in this standard.
This standard applies to machines which are manufactured after the date of issue
of this standard.
Best Sellers From Mechanical Sector
OS GSO 42:2015
GSO 42:2015
Omani Standard
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
OS GSO 159:1993
GSO 159:1993
Omani Standard
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
Recently Published from Mechanical Sector
GSO ISO 21384-2:2024
ISO 21384-2:2021
Gulf Standard
Unmanned aircraft systems — Part 2: UAS components
GSO ISO 23598:2024
ISO 23598:2021
Gulf Standard
Mechanical joining of sheet materials — Destructive testing of joints — Specimen dimensions and procedure for mechanized peel testing of single joints
GSO ISO 11114-6:2024
ISO 11114-6:2022
Gulf Standard
Gas cylinders — Compatibility of cylinder and valve materials with gas contents — Part 6: Oxygen pressure surge testing
GSO EN 14622:2024
EN 14622:2005
Gulf Standard
Devices to prevent pollution by backflow of potable water - Air gap with circular overflow (restricted) - Family A, type F