OS GSO ISO 5240:2015
ISO 5240:1994
Omani Standard
Current Edition
·
Approved on
03 September 2015
Textile machinery and accessories -- Warp creels -- Main dimensions
OS GSO ISO 5240:2015 Files
English
3 Pages
Current Edition
Reference Language
18.1 OMR
OS GSO ISO 5240:2015 Scope
This International Standard establishes terminology for warp creels and specifies their main dimensions.
The pitches Ρ should be applied for simple warp creels and only for packages unwound overend. For magazine warp creels , the same pitches should be applied in the vertical direction, and twice-indicated values in the horizontal.
Best Sellers From Mechanical Sector
OS GSO 42:2015
GSO 42:2015
Omani Standard
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
OS GSO 159:1993
GSO 159:1993
Omani Standard
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
Recently Published from Mechanical Sector
GSO EN 13445-6:2024
EN 13445-6:2021
Gulf Standard
Unfired pressure vessels - Part 6: Requirements for the design and fabrication of pressure vessels and pressure parts constructed from spheroidal graphite cast iron
GSO ISO 11154:2024
ISO 11154:2023
Gulf Standard
Road vehicles — Roof load carriers
GSO ISO 10468:2024
ISO 10468:2023
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes
— Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors