OS GSO ISO 8384:2014

ISO 8384:2000
Omani Standard   Current Edition · Approved on 25 December 2014

Ships and marine technology -- Dredgers -- Vocabulary

OS GSO ISO 8384:2014 Files

English 43 Pages
Current Edition Reference Language
27.27 OMR

OS GSO ISO 8384:2014 Scope

This International Standard specifies terms and definitions relating to dred­gers, with the aim of giving clear enough defini­tions for every term for them to be under­stood by all special­ists. It applies only to equipment which is used for the creation and mainten­ance of navi­gable waterways and the extraction of soil. The terms specified in this Inter­na­tional Standard are intended to be used in do­cumentation of all kinds. Use of syn­onyms for the standar­dized terms, which are generally not included in this Stan­dard, is not recommended. Certain stan­dardized terms are also given with their abridged version: these may be used in cases where no possibility of mis­inter­pretation can arise. Combination of terms are allowed in ap­plication. In cases when a definition contains a term defined elsewhere in the Stan­dard, the corresponding item number follows in brackets.

Best Sellers From Mechanical Sector

OS GSO 42:2015
GSO 42:2015 
Omani Standard
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
OS GSO 159:1993
GSO 159:1993 
Omani Standard
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS

Recently Published from Mechanical Sector

GSO ISO 11154:2024
ISO 11154:2023 
Gulf Standard
Road vehicles — Roof load carriers
GSO ISO 10468:2024
ISO 10468:2023 
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes — Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023 
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors
GSO ISO 11114-5:2024
ISO 11114-5:2022 
Gulf Standard
Gas cylinders — Compatibility of cylinder and valve materials with gas contents — Part 5: Test methods for evaluating plastic liners