OS GSO ISO 4759-3:2013
ISO 4759-3:2000
Omani Standard
Current Edition
·
Approved on
01 April 2013
Tolerances for fasteners -- Part 3: Plain washers for bolts, screws and nuts -- Product grades A and C
OS GSO ISO 4759-3:2013 Files
English
6 Pages
Current Edition
Reference Language
OMR
33.54
OS GSO ISO 4759-3:2013 Scope
This part of ISO 4759 establishes a selection of tolerances for use in the preparation of ISO product standards for
punched plain washers of product grades A and C, for use with bolts, screws and nuts of nominal thread diameters
of from 1 mm to 150 mm inclusive.
It is recommended that these tolerances also be used for non-standard washers.
Best Sellers From Mechanical Sector
OS GSO 42:2015
GSO 42:2015
Omani Standard
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
OS GSO 159:1993
GSO 159:1993
Omani Standard
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
Recently Published from Mechanical Sector
GSO 1796:2007
Gulf Standard
Methods of test for two pieces aluminum round cans used for canning food (Beverages & stuffs
GSO 230:2005
Gulf Standard
MOTOR VEHICLES —
BRAKE FLUID – SIMULATED SERVICE
PERFORMANCE TEST
OS GSO ISO 581:1997
ISO 581:1980
Omani Standard
Weldability- definition .
OS GSO ISO 4548-2:2002
ISO 4548-2:1997
Omani Standard
METHODS OF TEST FOR FULL-FLOW LUBRICATING
OIL FILTERS FOR INTERNAL COMBUSTION
ENGINES - PART 2: ELEMENT BY-PASS VALVE
CHARACTERISTICS