ISO 12624:2022
مواصفة قياسية دولية
الإصدار الحالي
اعتمدت بتاريخ
11 أغسطس 2022
Thermal insulating products for building equipment and industrial installations — Determination of trace quantities of water-soluble chloride, fluoride, silicate, sodium ions and pH
ملفات الوثيقة ISO 12624:2022
null صفحات
الإصدار الحالي
مجال الوثيقة ISO 12624:2022
This document specifies the equipment and procedures for determining trace quantities of the water-soluble chloride, fluoride, silicate and sodium ions in an aqueous extract of the product. It also describes a procedure for the determination of the pH of the aqueous extract. It is applicable to thermal insulating products.
NOTE The determination of these parameters can be relevant for thermal insulating products intended for application to stainless austenitic steel surfaces. The presence of chloride, fluoride, silicate and sodium ions under certain conditions can influence the risk of stress corrosion cracking. See Annex B for further information on general use of this document.
الأكثر مبيعاً
GSO 150-2:2013
مواصفة قياسية خليجية
فترات صلاحية المنتجات الغذائية - الجزء الثاني :
فترات الصلاحية الاختيارية

OS GSO 150-2:2013
GSO 150-2:2013
مواصفة قياسية عمانية
فترات صلاحية المنتجات الغذائية - الجزء الثاني :
فترات الصلاحية الاختيارية


OS GSO 150-1:2013
GSO 150-1:2013
مواصفة قياسية عمانية
فترات صلاحية المنتجات الغذائية - الجزء الأول : فترات الصلاحية الإلزامية


GSO 150-1:2013
لائحة فنية خليجية
فترات صلاحية المنتجات الغذائية - الجزء الأول : فترات الصلاحية الإلزامية

اعتمدت مؤخراً
ISO 15500-13:2023
مواصفة قياسية دولية
Road vehicles — Compressed natural gas (CNG) fuel system components — Part 13: Pressure relief device (PRD)

ISO/TS 11007-2:2023
مواصفة قياسية دولية
Petroleum products and lubricants — Determination of rust-prevention characteristics of lubricating greases — Part 2: Method with water wash-out

ISO 13583-2:2023
مواصفة قياسية دولية
Centrifugally cast steel and alloy products — Part 2: Heat-resistant materials

ISO 7784-1:2023
مواصفة قياسية دولية
Paints and varnishes — Determination of resistance to abrasion — Part 1: Method with abrasive-paper covered wheels and rotating test specimen
