ISO 20975-1:2023

مواصفة قياسية دولية   الإصدار الحالي · اعتمدت بتاريخ ٢٤ يناير ٢٠٢٣

Fibre-reinforced plastic composites — Determination of laminate through-thickness properties — Part 1: Direct tension and compression tests

ملفات الوثيقة ISO 20975-1:2023

الإنجليزية 19 صفحات
الإصدار الحالي
60.88 OMR

مجال الوثيقة ISO 20975-1:2023

This document specifies methods for determining the through-thickness properties (i.e. strength, modulus of elasticity, Poisson’s ratio and strain-to-failure) of fibre-reinforced plastic composites using either rectangular prism and/or waisted block specimens. The methods are suitable for use with a variety of aligned and non-aligned, continuous, and discontinuous fibre formats, with both thermoset and thermoplastic matrices, ranging from 20 mm to 40 mm in thickness.

Three specimen types are described in this document. These are:

    Type I - fixed rectangular cross-section along length of specimen. It is the preferred specimen for determining elastic properties.

    Type II - waisted rectangular cross-section, variable cross-section along length of specimen. It is only suitable for determining tensile strength values and is the preferred specimen for highly anisotropic and thermoplastic materials.

    Type III - waisted rectangular cross-section, fixed cross-section along the gauge-length of specimen. It is used to provide both elastic and strength property data and is the preferred specimen for generating a full stress-strain response.

Specimen types I and II are also suitable for use with unreinforced plastics but are unsuitable for use with rigid cellular materials and sandwich structures containing cellular materials.

Two testing modes are covered:

    Method A – Tension

    Method B – Compression

الأكثر مبيعاً

GSO 150-2:2013
 
مواصفة قياسية خليجية
فترات صلاحية المنتجات الغذائية - الجزء الثاني : فترات الصلاحية الاختيارية
OS GSO 150-2:2013
GSO 150-2:2013 
مواصفة قياسية عمانية
فترات صلاحية المنتجات الغذائية - الجزء الثاني : فترات الصلاحية الاختيارية
OS GSO 2055-1:2015
GSO 2055-1:2015 
مواصفة قياسية عمانية
الأغذية الحلال – الجزء الأول : الاشتراطات العامة للأغذية الحلال
GSO 2055-1:2015
 
لائحة فنية خليجية
الأغذية الحلال – الجزء الأول : الاشتراطات العامة للأغذية الحلال

اعتمدت مؤخراً

OS 1658:2025:2025
 
مواصفة قياسية عمانية
أكياس القمامة المستخدمة لمرة واحدة
ISO 7718-2:2025
 
مواصفة قياسية دولية
Aircraft — Passenger doors interface requirements for connection of passenger boarding bridge or passenger transfer vehicle — Part 2: Upper deck doors
ISO/IEC/IEEE 32430:2025
 
مواصفة قياسية دولية
Software engineering — Software non-functional size measurement
ISO 10218-1:2025
 
مواصفة قياسية دولية
Robotics — Safety requirements — Part 1: Industrial robots